From Hyd Roller to Hyd Flat Tappet???
Thread Starter
Member
Joined: Jun 2002
Posts: 303
Likes: 0
From: Orlando, Fl / Ne.Philly
Car: 96 SS, 88 IROC
Engine: Lt1, TPI
Transmission: m6,a4
Axle/Gears: 3.90. 3.73
From Hyd Roller to Hyd Flat Tappet???
Aight Guys im going to be doing a top end upgrade on my 305.... I have a 89 Firebird wit a 305, so i "GUESS" its a Hyd Roller Cam setup... Well Summit and Jegs both have specials that include cam lifters springs timing chain for like 300$.... My question is can I put that in my block being it seems cheaper to get setup as to getting just the crane hyd roller cam which i beleive runs about like 239$ for just the cam.....
Senior Member
Joined: Apr 2000
Posts: 860
Likes: 0
From: Alberta, Canada
Car: 1987 IROC
Engine: Vortec 350 TPI
Transmission: 7004r
If your roller lifters don't have too many miles, they can be reused.. unlike hyd flat lifters.
but to answer your question, yes a hyd flat tappit cam will fit into your roller block np. your pushrods will need to be a different length though, so get pushrods for a hyd flat tappit V8.
but to answer your question, yes a hyd flat tappit cam will fit into your roller block np. your pushrods will need to be a different length though, so get pushrods for a hyd flat tappit V8.
Thread
Thread Starter
Forum
Replies
Last Post
KO1
Engine/Drivetrain/Suspension Parts for Sale
16
Oct 15, 2015 05:00 PM
skinny z
Engine/Drivetrain/Suspension Parts for Sale
5
Oct 5, 2015 06:23 PM