LT1 Intake and heads
Thread Starter
Joined: Jan 2003
Posts: 330
Likes: 27
From: Raymond, Wi
Car: 87 Formula, 91 Trans Am
Engine: 355 tpi, 305tpi
Transmission: 700r4, 700r4
LT1 Intake and heads
I have the opportunity to pick up a pair of aluminum LT1 heads and intake for very cheap. What modifications would be needed to make these fit on a standard small block besides having a hole for the ditributor drilled? Thanks for any info.
Moderator
Joined: Jan 2000
Posts: 19,655
Likes: 309
JKris,
One of our members (John Millican) has a lot of experience with LT1 intake modifications for distributors. You might want to contact him for details.
One of our members (John Millican) has a lot of experience with LT1 intake modifications for distributors. You might want to contact him for details.
Supreme Member
iTrader: (1)
Joined: Feb 2000
Posts: 2,361
Likes: 1
From: Savannah, GA
Car: 1997 Jeep Wrangler
Engine: 4.0L
Transmission: 5 speed
Axle/Gears: 8.8 rear, 4.56 gears, 4:1 transfer
The LT1 heads will need to be modified to fit a gen1 SBC. I have never done it but here's a magazine scan of someone that has.
http://www.lt1intake.com/LT1_Retrofit.htm
After that the LT1 intake will need partially modified just for the distributor hole.
http://www.lt1intake.com/LT1_Retrofit.htm
After that the LT1 intake will need partially modified just for the distributor hole.
Joined: Feb 2000
Posts: 1,855
Likes: 13
From: St. Augustine, FL
Car: 89 GTA
Engine: 383
Transmission: 4L80E
Axle/Gears: 12 bolt-3.73
John, is your site down? The link times out, and the email I sent you bounced back.
Sorry to hijack your thread dood.
Sorry to hijack your thread dood.
Thread
Thread Starter
Forum
Replies
Last Post
ambainb
Camaros for Sale
11
Apr 25, 2016 09:21 PM
