Will this be a problem?
Thread Starter
Supreme Member
Joined: Apr 2002
Posts: 3,552
Likes: 5
From: New Jersey
Car: 86 Corvette, 89 IROC, 1999 TA
Engine: 350, 350, LS1
Transmission: 700r4, 700r4, T-56
Axle/Gears: 3.07, 373, 4.10
Will this be a problem?
i was puttin my new trans in today, a th350, and the torque converter slipped forward and spilled a decent amount of fluid out of it before i was able to get it back on all the way.. i finished installing the trans, will this be a problem or can i just top it off when im completely done?
Supreme Member
Joined: Apr 2001
Posts: 4,969
Likes: 0
From: USA
Car: yy wife, crazy.
Engine: 350, Vortecs, 650DP
Transmission: TH-350
Axle/Gears: 8.5", 3.42
If it didn't completely drain it, then you can just top it off after you let the car run for a while (warm up).
Thread
Thread Starter
Forum
Replies
Last Post
