what a PITA - my 400 won't start after reinstalling heads
Thread Starter
Supreme Member
Joined: Aug 1999
Posts: 1,443
Likes: 0
From: College Station, Tex USA
Car: 89rs
Engine: 400Sb
Transmission: Tremec 3550
what a PITA - my 400 won't start after reinstalling heads
Man this sob has been a pain. No matter what I do it seems to take 5 times longer on this car. Now I can't get it going again.
I checked the distributor and made sure I had spark. I tried ether but maybe I did not give it enough of a shot.
I am going to make sure I got it in right.
I am going to lock the hood down if I get it going again.
I checked the distributor and made sure I had spark. I tried ether but maybe I did not give it enough of a shot.
I am going to make sure I got it in right.
I am going to lock the hood down if I get it going again.
Make sure the rocker arms aren't tightened down too much. That will cause a no start condition. I had that problem a couple of weeks ago when I changed the heads on my car.
P.S. Did you remember to plug the wires back into the distributor? Just a thought.
------------------
Chris T's Website
1989 Trans Am GTA
2 1986 Grand Prixs
P.S. Did you remember to plug the wires back into the distributor? Just a thought.
------------------
Chris T's Website
1989 Trans Am GTA
2 1986 Grand Prixs
Thread Starter
Supreme Member
Joined: Aug 1999
Posts: 1,443
Likes: 0
From: College Station, Tex USA
Car: 89rs
Engine: 400Sb
Transmission: Tremec 3550
I checked those guys. But since there is nothing else it can be, I guess I get to check them about 2 or 3 other times until I find it.
Thread
Thread Starter
Forum
Replies
Last Post
backtothe80s
Suspension and Chassis
33
Sep 5, 2015 12:39 AM




