new plugs,cap,rotor,wires and now it wont run....
Junior Member
Joined: Nov 1999
Posts: 24
Likes: 0
From: DeKalb, Streamwood, Arlington Heights, IL, USA
Are you sure you bought all of the right parts? You could have possibly gapped the plugs wrong, but that is doubtful.
What kind of engine is it?
Did you forget to plug in wires that go to the distributor.
Make sure the plug wires are on right, if not, this will cause the car not to run. Find the fireing order and check the corespondence with the distributor cap. This is most likely the problem.
Good luck
-NIU2001
What kind of engine is it?
Did you forget to plug in wires that go to the distributor.
Make sure the plug wires are on right, if not, this will cause the car not to run. Find the fireing order and check the corespondence with the distributor cap. This is most likely the problem.
Good luck
-NIU2001
I had the same problem with my car so i put it in the shop, wasnt easy for me to do, and it was the copper coil around the rotor under the distributor cap, it was fried so they had to replace it.
------------------
91 Blue RS w/ASCD SS hood, K&N air, Flowmaster 80 series muffler, and Hypertech superchip.
------------------
91 Blue RS w/ASCD SS hood, K&N air, Flowmaster 80 series muffler, and Hypertech superchip.
Thread
Thread Starter
Forum
Replies
Last Post





