push rod swap from 882 heads to 083's ??
Thread Starter
Member
Joined: Apr 2003
Posts: 139
Likes: 0
From: Massachusetts
Car: 87 T/A
Engine: LM1 350
Transmission: 700 R4
push rod swap from 882 heads to 083's ??
This is probly a no brainer for some of you guys but..... can i use the same push rods while swapping the above heads ?? A friend is giving me 1.5 roller tip rockers to replace the stock rocker arms. Does anyone forsee a problem with this matchup ??? Would like to use the stock push rods to help keep cost down.
Joined: Mar 2000
Posts: 5,703
Likes: 132
From: Orange, CA
Car: '90 Trans Am-12.45@110.71
Engine: 355 w/AFR 195's Elem. 400/430 HP/TQ
Transmission: Tremec T-56
Axle/Gears: 12 Bolt 3.73
Push rods
Just make sure your 083's have a slot for the push rods and not a hole. With a hole you will need self-aligning rockers.
Thread
Thread Starter
Forum
Replies
Last Post
