need help on new motor.

Reply Subscribe

Thread Tools

Search this Thread

Sep 15, 2003 | 02:06 PM

icebird_1981

Thread Starter

Supreme Member

Joined: Sep 2002

Posts: 1,661

Likes: 0

From: Toronto

need help on new motor.

k i just went and got a rebuilt wiper motor. it has a black and red wire hanging out that i am suppost to hook up to something. what do i hook these wire up to???

Sep 15, 2003 | 02:35 PM

8Mike9

Supreme Member

Joined: Jul 1999

Posts: 5,183

Likes: 42

From: Oakdale, Ca

Car: 89 IrocZ

Engine: L98-ish

Transmission: 700R4

I'm just guessing here, but it should be easy to figure out when you remove the old motor.

Sep 15, 2003 | 02:36 PM

icebird_1981

Thread Starter

Supreme Member

Joined: Sep 2002

Posts: 1,661

Likes: 0

From: Toronto

old one was never there

Sep 15, 2003 | 02:37 PM

8Mike9

Supreme Member

Joined: Jul 1999

Posts: 5,183

Likes: 42

From: Oakdale, Ca

Car: 89 IrocZ

Engine: L98-ish

Transmission: 700R4

Then look for as plug near where it goes...hopefully the wiring is still intact.

Sep 16, 2003 | 01:08 AM

88IROC350TPI

Supreme Member

Joined: May 2001

Posts: 2,009

Likes: 5

From: Pitman, NJ

Car: '89 IROC-Z

Engine: Canfield 195 headed 358ci

Transmission: TH350, Art Carr 9.5"

Axle/Gears: 3.92 Dana 44

Most likely red = power, black = ground. My wiper motor has quite a few wires.... You sure you got the proper one?

Sep 16, 2003 | 06:31 AM

icebird_1981

Thread Starter

Supreme Member

Joined: Sep 2002

Posts: 1,661

Likes: 0

From: Toronto

well i am not positive, but i told the guy what car i had and it has the same plug fitting. but i dont have a clue were i hook those wires up. i would think that the plug would be the power and ground and what not.