MSD sells 22lbs PN 2017 and was wondering if 16 is to high or is ther a differance?

PN 2010 21 lb/hr12V Saturated Circuit12 Ohms
PN 2011 26 lb/hr 2 Ohms
PN 2012 34 lb/hr 2 Ohms
PN 2013 50 lb/hr 12 Ohms
PN 2014 72 lb/hr 4/1A Peak & Hold 2 Ohms
PN 2015 96 lb/hr 4/1A Peak & Hold 2 Ohms
PN 2016 19 lb/hr12V Saturated Circuit16 Ohms
PN 2017 22 lb/hr12V Saturated Circuit16 Ohms
PN 2018 38 lb/hr12V Saturated Circuit12 Ohms
PN 2019 24 lb/hr12V Saturated Circuit12 Ohms

 

Mkos,

16 ohm injectors should be just fine. Factory 19- and 22-lb/hr injectors have a load resistance of 16 ohms, so getting an identical solenoid coil should be a good thing.

------------------
Later,
Vader
------------------
"No matter how hard you try you can't stop us now"
Adobe Acrobat Reader 4.0

 

In fact, low impedance injectors may not work with your ECM.