I want to get the MSD 8.5mm Super Conductors for my '89 Formula 305 TPI. For those of you with these wires...did you get a custom length, or did you get the universal and cut them yourself? I don't want to mess with cutting them myself if I don't have to, but I haven't found a set specific to third gens. But I did see a set at Jeg's for "SB Chevy '88-up cars". Does this sound like the right set to get?

I also plan on getting the NGK plugs...any ideas on which ones or where to get them?

Thanks in advance!


------------------
1989 Formula WS6 M5
SLP cold air induction, K&N filter, TPIS modified MAF, TPIS 52mm TB w/ airfoil, Random Tech cats, SLP cat-back, TPIS AFPR, March underdrive pulley, Accel 300+ coil & 8.8mm wires, Bosch Platinum+4 plugs, Hypertech 160°F t-stat & fan switch, Hypertech Streetrunner chip, Centerforce dual-friction clutch, PST front suspension kit, PowerStop cross-drilled rotors, Porterfield Carbon Kevlar pads, Russell SS brake lines, Firehawk SZ50 EP P255/50ZR16.

G-Tech Pro measurements:
0-60 mph: 6.0 sec
212 RWHP

1/8 mile results: 9.74 sec @ 74.5 mph; 0-60 ft @ 2.35 sec; +0.46 reaction

2001 Trans Am WS6 A4
Stock

More info at website:
www.fbody.com/members/stevenmh

 

Call up summit, tell them the year and engine of your car, they'll sell you the custom-length superconductors. I bought mine through them, some of the wires were a few inches longer than the stock ones but none were shorter. In fact, I have the invoice still. The part number of the set I got is MSD-31839 (that's a summit part number). They were $58.95 + handling.

I can't offer any advice on NGK plugs as I've never bought them :-). Right now I'm running good old AC Delcos.

[This message has been edited by Eggplant Jeff (edited December 01, 2000).]