Hurst Dual Gate Owners
#1
Junior Member
Thread Starter
Join Date: Mar 2000
Location: Cleveland, Ohio
Posts: 2
Likes: 0
Received 0 Likes
on
0 Posts
Hurst Dual Gate Owners
I started installing a Hurst Dual Gate 2 last night and for some reason the factory cable seems to be about 1" short. I was able to get it to work but now my cable is fairly tight and I can't achieve the proper front to rear alignment to get the shifter to properly correspond to the markings on the top cover plate because of the short cable. Also, the side to side alignment between the shifter, top plate, and console is out by about 1/2 inch. I called the Hurst tech line and they said they havn't heard of this problem. Has anyone run into these problems? any suggestions?
------------------
89 IROC 5.7 Auto
14.22@97mph
[This message has been edited by IROCSteve (edited December 07, 2000).]
------------------
89 IROC 5.7 Auto
14.22@97mph
[This message has been edited by IROCSteve (edited December 07, 2000).]
Thread
Thread Starter
Forum
Replies
Last Post
Hotrodboba400
Firebirds for Sale
3
12-10-2019 07:07 PM
jer4251
Engine/Drivetrain/Suspension Parts for Sale
3
09-27-2015 09:52 PM