l98 heads on stock engine
Thread Starter
Junior Member
Joined: May 2003
Posts: 34
Likes: 0
From: South Jersey
l98 heads on stock engine
Just wodering if there is anything special about the l98 heads that would not allow them to be put on a rebuilt 327 30 over with a little cam and carb?Reason being i have these ready to go and no extra dough for real nice heads!Anything i should know????
Thanx
Thanx
Joined: Mar 2000
Posts: 43,187
Likes: 46
From: Littleton, CO USA
Car: 82 Berlinetta/57 Bel Air
Engine: L92/LQ4 (both w/4" stroke)
Transmission: 4L80E/4L80E
Axle/Gears: 12B-3.73/9"-3.89
Other than the different intake bolt angles and center-bolt valve covers, no, nothing to prevent them going on a 327.
Supreme Member
Joined: Sep 2001
Posts: 6,111
Likes: 53
From: Ontario, Canada
Car: 1988 Firebird S/E
Engine: 406Ci Vortec SBC
Transmission: TH-350/3500stall
Axle/Gears: 7.5" Auburn 4.10 Posi-Traction
You may want to use some thicker intake manifold gaskets if you'll be using an older pre-87 intake manifold.
Both felpro and Mr. gasket sell these.
Both felpro and Mr. gasket sell these.
Thread
Thread Starter
Forum
Replies
Last Post
NinjaNife
Tech / General Engine
27
Aug 23, 2015 11:49 AM