Home brew RAM AIR
Thread Starter
Supreme Member
Joined: Oct 2000
Posts: 2,264
Likes: 0
Home brew RAM AIR
Iv eheard about People removing the hi beams To rig Up a ram Air setup, And was wondering, Has anyone discoverd a scoop that approximately fits this opening ?
I dont really want to just stick some flexible tubing out there and call it Ram air, Id like to get a little more professional than that.
Thanks.
------------------
60 Ranchero - Project ( Money Hole )
85 Sport Coupe LG4 - Daily Driver
Livin' the Stereotype
I dont really want to just stick some flexible tubing out there and call it Ram air, Id like to get a little more professional than that.
Thanks.
------------------
60 Ranchero - Project ( Money Hole )
85 Sport Coupe LG4 - Daily Driver
Livin' the Stereotype
Supreme Member
Joined: Jul 1999
Posts: 1,431
Likes: 1
From: Huntsville, AL
Car: '00 Chevrolet Corvette
Engine: LS1
Transmission: 4L60E
Axle/Gears: 2.73
This website has that kinda stuff. They have some scoops they designate as "headlight" scoops...I'm not too sure on the specifics, but somebody on here had this under their hood. Contact them and ask 'em.
-Mark W.
'88 SC Camaro w/ 305 TBI
-Mark W.
'88 SC Camaro w/ 305 TBI
Supreme Member
Joined: Nov 2000
Posts: 1,069
Likes: 1
From: So. Cal, L.A.
Car: '88 Firebird Formula 350
Engine: Built 383 TPI
Transmission: Built 700r4
Axle/Gears: 9 bolt, 3.27:1 Posi
How much more profesional can you get. That's how the aftermarket started. Someone jimmy rigged something up, then made it look good, then sold it. You can easily make a clean looking ram air with some flex hose, duct tape, and spray paint.
------------------
'82 Firebird, dead stock, 9 bolt disc rear, over 200,000 miles and still going strong, more to come...
http://www.spinfrenzy.com/stingerssx...easures.html#4
------------------
'82 Firebird, dead stock, 9 bolt disc rear, over 200,000 miles and still going strong, more to come...
http://www.spinfrenzy.com/stingerssx...easures.html#4
Thread
Thread Starter
Forum
Replies
Last Post