open- or closed-loop?
Thread Starter
Member
Joined: Feb 2002
Posts: 136
Likes: 0
From: Bradenton, FL
Car: 89 GTA
Engine: 5.7 TPI
Transmission: 700R4
open- or closed-loop?
Short of hooking up to a diagnostic computer, is there a way to tell if running in open or closed loop? 89 350 TPI very little mods (yet 
)
) 
Moderator
Joined: Jan 2000
Posts: 19,655
Likes: 309
Yes, you can tell if the ECM is in open- or closed-loop mode, and determine if the system is rich or lean, simply by entering the Field Service Mode.
Field Service Mode
On the OBDI ECMs, you can jump 'A' and 'B' terminals on the ALDL while the engine is running.
WARNING! This must be done after the engine is running. This is called "Field Service Mode" and will not harm the ECM.
If the ECM is in Open-Loop mode, the SES light will flash rapidly, about 2½ times per second. If it's in Closed-Loop mode, it will flash about once per second. When in Closed Loop mode, flashing less than once per second indicates the ECM is enriching the mixture above the 128 count base line. Flashing more than once per second indicates the ECM is leaning the mixture below the 128 base line.
Field Service Mode
On the OBDI ECMs, you can jump 'A' and 'B' terminals on the ALDL while the engine is running.
WARNING! This must be done after the engine is running. This is called "Field Service Mode" and will not harm the ECM.
If the ECM is in Open-Loop mode, the SES light will flash rapidly, about 2½ times per second. If it's in Closed-Loop mode, it will flash about once per second. When in Closed Loop mode, flashing less than once per second indicates the ECM is enriching the mixture above the 128 count base line. Flashing more than once per second indicates the ECM is leaning the mixture below the 128 base line.
Thread
Thread Starter
Forum
Replies
Last Post
