3.5Gen Camaro
Thread Starter
Senior Member
Joined: Jul 2003
Posts: 729
Likes: 0
From: Texas
Car: Right now 93 Lumina
Engine: 3.4 DOHC
Transmission: 4T60-E
3.5Gen Camaro
I was thinking of maybe saving my money for a little bit longer to just buy a complete 4th gen LT1 and using the following
Engine (complete)
Trans (if its a Manual)
Drive Shaft
Rear axle
Gas Tank (maybe)
Seats
Center Counsile
Dash
What do yeall think? Should i just buy them sepreatly? or a complete car? or should i just ditch the 3rd gen and fix up the 4th gen?(not really a option)
Engine (complete)
Trans (if its a Manual)
Drive Shaft
Rear axle
Gas Tank (maybe)
Seats
Center Counsile
Dash
What do yeall think? Should i just buy them sepreatly? or a complete car? or should i just ditch the 3rd gen and fix up the 4th gen?(not really a option)
Supreme Member
Joined: Sep 2002
Posts: 2,967
Likes: 0
From: Elk Grove Village, IL
Car: 1989 TransAm GTA
Engine: One sweet modified 355 TPI.
Transmission: The kind that shifts....
Actually, I think its more like 3.75 gen Camaro. the entire bay is 4th gen I think. Down to the strut towers.
Thread Starter
Senior Member
Joined: Jul 2003
Posts: 729
Likes: 0
From: Texas
Car: Right now 93 Lumina
Engine: 3.4 DOHC
Transmission: 4T60-E
the cheapest way i could probably do this is if i get the V6 wrecked base model. I will most likeley use the same thing except the engine and transmission.
P.S. Is the axle on a v6 the same as the one on a V8
P.S. Is the axle on a v6 the same as the one on a V8
Thread
Thread Starter
Forum
Replies
Last Post
84z96L31vortec
Tech / General Engine
7
Aug 20, 2017 12:16 AM






