Exhaust header swap Question Please HELP
Thread Starter
Supreme Member
Joined: Jan 2001
Posts: 1,116
Likes: 0
From: Rio Rico, AZ 85648
Car: 1989 IROC-1
Engine: L98
Transmission: 700r4
Exhaust header swap Question Please HELP
I posted this in the exhaust section as well, but there aren't as many people reading there, so I'll place it here as well...
First off, I have an 84Z, L69, and am doing a cam, intake and header swap. All of these will be good applications for my future project except for the headers, so I just picked up a cheap set of Summit headers....I know, I know....but I'll only need them for a few months.
Anyhow, here's my problem, and I'm sure there is a simple solution, but I don't know the answer.
The stock exhaust system has a 2 hole mounting bracket and the new headers have the 3 hole bracket....what gives???? Of course only one of the holes lines up with these two patterns, so what do I do?
Thanks again.
First off, I have an 84Z, L69, and am doing a cam, intake and header swap. All of these will be good applications for my future project except for the headers, so I just picked up a cheap set of Summit headers....I know, I know....but I'll only need them for a few months.
Anyhow, here's my problem, and I'm sure there is a simple solution, but I don't know the answer.
The stock exhaust system has a 2 hole mounting bracket and the new headers have the 3 hole bracket....what gives???? Of course only one of the holes lines up with these two patterns, so what do I do?
Thanks again.
Thread
Thread Starter
Forum
Replies
Last Post