Hey all. I just found out the trick flow 23 degree heads have angle plugs. Does anyone run these heads with Edelbrock headers ? I'm worried they wont fit and I might have to get some really short plugs.

------------------
92 Z28 5.7
------------------
Ported stock heads, XR270HR-10 cam, TES headers
Crane AFPR, Flowmaster catback, MSD ignition
#24 SVO injectors, 1LE aluminum driveshaft.

Best ET 13.3@107 mph

Click here to see my car at Truspeed.org
Check out Truspeed
Check out the Bin Archive

 

btt

 

I think the new design angle plugs have quite a bit less angle than the originals.

In most cases, they fit with 90 degree boots and in some cases short plugs. I had the 1 3/4 inch hooker supercomps on a set of Track1s with angle plugs (and they really have some angles), and the #3 hole was the only real close one.

normally, the problem comes when you try to change plugs. A socket will not fit on most combinations and you end up using a 5/8 or 13/16 boxend.

[This message has been edited by jcb999 (edited March 14, 2001).]