Sagging door and Hatch Motor Replacing
Thread Starter
Junior Member
Joined: Feb 2000
Posts: 37
Likes: 0
From: So Cal
Car: Z71
Engine: 5.3
Transmission: Auto
Sagging door and Hatch Motor Replacing
I have to replace the hatch motor and the driver door on my car is sagging. Please help me out and give me detailed directions or links to tech articles to get this done. Pictures would help. Thank you very much.
------------------
Black 1990 Iroc 305 5 speed
http://www.shamanland.com/wruth/
------------------
Black 1990 Iroc 305 5 speed
http://www.shamanland.com/wruth/
Supreme Member
Joined: Feb 2000
Posts: 1,515
Likes: 0
From: Midlothian,VA. 23112-6108
Car: 1982 Z-28
Engine: 5.0 w/ Holly carb
Transmission: TH-700R4
I had to replace both upper door hinges on my car.WHATTA BITCH it was too. But I am working on a fix.
------------------
82Z 305 w/comp 270 magnum cam,Edelbrock Performer RPM,Holly 1850-4,serpentine belt drive.TH700R4 w/B&M holeshot 2000 converter,& megashifter.1LE front brakes, 9bolt 3.27 w/1LE rear brakes.Aluminum driveshaft,boxed rear susp.poly everything,IROC swaybar+wonderbar. 70mph@2200rpm ASE Master Tech plus L2
also recently obtained a
'69 chevelle SS396 w/Turbo 400,3.31 posi,11.0 to 1, headers,etc. Latest project car,'86 IROC stock 305TPI hit on left side,but not too bad
------------------
82Z 305 w/comp 270 magnum cam,Edelbrock Performer RPM,Holly 1850-4,serpentine belt drive.TH700R4 w/B&M holeshot 2000 converter,& megashifter.1LE front brakes, 9bolt 3.27 w/1LE rear brakes.Aluminum driveshaft,boxed rear susp.poly everything,IROC swaybar+wonderbar. 70mph@2200rpm ASE Master Tech plus L2
also recently obtained a
'69 chevelle SS396 w/Turbo 400,3.31 posi,11.0 to 1, headers,etc. Latest project car,'86 IROC stock 305TPI hit on left side,but not too bad
Thread
Thread Starter
Forum
Replies
Last Post
