ok on my 84 TA 305 HO 4bbl...i was changin the plugs on the drivers side and i notices a dark green wire hangin there and it has a white conector on the end....its not real long and hangs near the manifold on the drivers side....it lso is loomed together with a black wire that goes to the carb

does anyone have any idea what the wire is for and where it goes.....i could seea place where it could go

 

Can't pinpoint anything in the wiring diagrams, and I'm not real familiar with Q-jet cars, but there should only be four things on that side of the engine, The O2, the temp sender for the guage, on some cars, a wire going to the steering box, and that wire going to the proportioning valve under the master cylinder.

As always, I could have forgotten something, and I may be wrong..

[This message has been edited by Macgyver (edited March 30, 2001).]

 

yea....i figure that i would be able to see where it goes but i tried to pinpoint anything in reach of it.....also its kinda melted a bit on the conector wich makes me think it was near the manifold....could it just be an extra unused wire?

 

That's probably the temp gauge sending unit wire... the sender is between the #1 and #3 plugs

------------------
"So many Mustangs, so little time..."
ICON Motorsports

[This message has been edited by RB83L69 (edited March 30, 2001).]