I ahve been having a bit of troubles with my 91 formula350 lately. Recently i blew a head gasket and with that i replaced the timing chain, water pump, cap, rotor, plugs, wires, Knock sensor, electronic spark module, oxygen sensor, egr valve, and replaced the drusty olf vacume lines. well after all of this my poor car still runs like poo! It seems to have a missing/falls on its face at about 3000rpm. Well i went out and bought the cheapy actron code reader at Autozone and it when i hooked it up it gave me a code of (32) After replacing the EGR valve last week i cleared the codes and the car ran sweet for about 3 minutes. i am stumped, i would love any advice on this dilema of mine.


Thanks,

Greg

 

I dunno about the car running bad, but I do know that the chances of the code 32 causing it to run bad are like non existent. unless its only throwing the code 32 because your ecu is junk........?

 

well i am not sure if it is the computer. the code 32 says EGR so i changed that last week and cleared the codes. then a couple days ago the light came on again and said 32 so i was thinking of changing the EGR Solenoid. I have no idea.