Difficult getting heads back on
Thread Starter
Member
Joined: Dec 2003
Posts: 170
Likes: 0
From: Atascadero, CA
Car: 88 Iroc
Difficult getting heads back on
Any of you have any problem just trying to get your heads over those 2 dowels on the block? I was out there forever trying, but couldn't get it. *** i hope i don't have a warped block.....
Supreme Member
Joined: Jul 1999
Posts: 18,457
Likes: 16
From: Loveland, OH, US
Car: 4
Engine: 6
Transmission: 5
They're supposed to be a tight fit.
Put them where they go; have a helper hold them there if necessary; and use the 2 medium length bolts to GENTLY draw the head on over the dowels. They should go on with less than 20 ft-lbs on the bolts.
Put them where they go; have a helper hold them there if necessary; and use the 2 medium length bolts to GENTLY draw the head on over the dowels. They should go on with less than 20 ft-lbs on the bolts.
Thread
Thread Starter
Forum
Replies
Last Post
eightsixseven
Tech / General Engine
2
Dec 16, 2024 01:50 PM
theshackle
Tech / General Engine
4
Mar 5, 2017 06:37 PM
