What the hell is up with the Wells' MAF?!?!
Thread Starter
Junior Member
Joined: Oct 2000
Posts: 21
Likes: 0
From: Coppell, TX
What the hell is up with the Wells' MAF?!?!
I have called six parts stores here in Dallas and all of them said the same thing, "I wont touch wells with a 10 foot pole!" So what is the deal with these guys are their parts bad quality or something. I can get a Bosch replacement from TPIS for 249.00 and wanted to know what you guys think I should do?
Member
Joined: Jan 2000
Posts: 183
Likes: 0
From: San Diego, CA
In the power adder board someone posted something about a wiring harness being available so you can use a ford MAF on TPI. If my MAF ever goes that is what I am doing. The ford ones can be picked up used all over the place for a few bucks... and you can upgrade to a larger MAF too. I wonder how expensive the harness is tho.
Supreme Member
Joined: Jan 2001
Posts: 1,978
Likes: 0
From: PA
Car: 88 Firebird WS6
Engine: 350 TPI
Transmission: T56
Axle/Gears: 3.42
You could get them alot cheaper than that though.... I got a remanufactured bosche MAF from a local (Cee-Kay) part store for about $100.
Member
iTrader: (1)
Joined: May 2001
Posts: 332
Likes: 0
From: So Cal / El Mirage, AZ
Car: 86 Z28
Engine: 350 TPI
Transmission: 700R4
Axle/Gears: 3.23
Look here:
https://www.thirdgen.org/messgboard/...ML/002095.html
I just ordered one today and they told me I should have it by Friday.
https://www.thirdgen.org/messgboard/...ML/002095.html
I just ordered one today and they told me I should have it by Friday.
Thread
Thread Starter
Forum
Replies
Last Post