oil pressure sender
Thread Starter
Junior Member
Joined: Nov 2004
Posts: 70
Likes: 0
From: Long Island
Car: 91 Camaro RS white w/ T-tops
Engine: original 305TBI 140,000mi
Transmission: automatic (although standard would be preffered)
where to get an oil pressure sensor
where get i get an oil pressure sender/sensor for a 91 RS maro?
Also is there a mech gauge that can just be put on the block: sensor gauge and all in one spot on the block without routing into to instrument panel or console? I know this sounds stupid because you would have to open the hood to know the pressure but it seems much easier
Also is there a mech gauge that can just be put on the block: sensor gauge and all in one spot on the block without routing into to instrument panel or console? I know this sounds stupid because you would have to open the hood to know the pressure but it seems much easier
Last edited by csi1286; Nov 4, 2004 at 09:26 PM.
Senior Member
iTrader: (1)
Joined: Feb 2003
Posts: 908
Likes: 0
From: parishville NY upstate
Car: 86 IROC-Z
Engine: 305 TPI
Transmission: 700R4
Axle/Gears: 3.42s/posi/disc
you can get a sending unit at any parts store for a max of like 20 bux... do i the right way and just replace the sending unit man... dont cob it up...its an easy fix...
Joined: Dec 2000
Posts: 2,341
Likes: 151
From: Cincinnati,Ohio
Car: 1991 BandittII Firebird
Engine: 5.7 HSR
Transmission: 700R4
Axle/Gears: 3.27 9 bolt
From Auto Zones web site
Oil pressure switch
it would be more time comsuming to "rig" up another gauge for oil pressure than using the OEM replacment sending unit.the hardest part is that it's a little ocward to get too.
Oil pressure switch
it would be more time comsuming to "rig" up another gauge for oil pressure than using the OEM replacment sending unit.the hardest part is that it's a little ocward to get too.
Thread Starter
Junior Member
Joined: Nov 2004
Posts: 70
Likes: 0
From: Long Island
Car: 91 Camaro RS white w/ T-tops
Engine: original 305TBI 140,000mi
Transmission: automatic (although standard would be preffered)
that i now know how the hell do i get this thing off. and what size wrench/socket or whatever should it be? seems like about 1 3/16 unfortunately that cannot be purchased anywhere.
thanks all
thanks all
Thread
Thread Starter
Forum
Replies
Last Post