fast idlin iroc!!!!!!
fast idlin iroc!!!!!!
i didn't know if all camaros had this problem or not but when goin down the highway when i am doin 70mph and let off the gas the rpms stay reving high at 2500 and instead of slowin down the car keeps going faster and the other night i went into a takeout and there was crush rock on the ground and the car was revin high and when i pushed in on the brakes the front tires slid across the rocks because the car was reving 1500 and still pullin. i was wonderin if anyone had any ideas on what that could be??????????????
Sounds to me like a major vacumn leak. Have u performed any mods to your motor prior to the problem? Any check engine light codes? We need more info.
Corey
------------------
86 Tramaro 90% Trans Am/ 10% IROC/Z (nose, hood,& fenders)
Trans Am Mods as of 1/10/01
3inch
T.E.S/Flowmaster setup,gutted cat,gutted maf,relocated mat,373 gears,upgraded factory chip,255 lph walpro f/pump & throttle body coolant bypass
njdaewoo@excite.com
New mods as of 6/10/01:
383sb engine
Comp Cam Xteme XR264hr-12
smog pump by-pass
Corey
------------------
86 Tramaro 90% Trans Am/ 10% IROC/Z (nose, hood,& fenders)
Trans Am Mods as of 1/10/01
3inch
T.E.S/Flowmaster setup,gutted cat,gutted maf,relocated mat,373 gears,upgraded factory chip,255 lph walpro f/pump & throttle body coolant bypass
njdaewoo@excite.com
New mods as of 6/10/01:
383sb engine
Comp Cam Xteme XR264hr-12
smog pump by-pass
Is your minimum air speed adjusted properly? Check the tech articles section for this procedure. Check for vacuum leaks like 86 said.
bsa
------------------
"If they do not run, Then they will die." - Stonewall Jackson
#3
'87 IROC, 355 TPI, Converted to SD, 700R4, B&M Megashifter, 3.42, Trick Flow Twisted Wedge Heads, Edelbrock Intake, Accel Runners, Comp Cam, Crane Gold rockers, Lucas 24# injectors, Edelbrock headers, Flowmaster 3'' exhaust, Mallory Ignition, Transgo Performance Shift Kit, Corvette Servo, 2,000 Stall Torque Converter
bsa
------------------
"If they do not run, Then they will die." - Stonewall Jackson
#3
'87 IROC, 355 TPI, Converted to SD, 700R4, B&M Megashifter, 3.42, Trick Flow Twisted Wedge Heads, Edelbrock Intake, Accel Runners, Comp Cam, Crane Gold rockers, Lucas 24# injectors, Edelbrock headers, Flowmaster 3'' exhaust, Mallory Ignition, Transgo Performance Shift Kit, Corvette Servo, 2,000 Stall Torque Converter
Thread
Thread Starter
Forum
Replies
Last Post
Fast355
DFI and ECM
14
Dec 2, 2016 06:33 PM
mustangman65_79
Body
3
Aug 11, 2015 03:17 PM




