Can't figure out how to put the power steering pump back on.

Reply Subscribe

Thread Tools

Search this Thread

Jul 21, 2001 | 09:19 PM

Tec21-CamaroLover

Thread Starter

Junior Member

Joined: Mar 2001

Posts: 64

Likes: 0

From: Calgary, Alberta, CANADA

Can't figure out how to put the power steering pump back on.

I need a picture or just some good directions of how to install the power steering pump.

I took it off, but now i can't get it back on... Which bolt holes do i use?

It's an '85 TranAM 305, no AC

------------------
'85 Trans Am 305
(My new baby)
-K&N filter -Edelbrock Performer Intake Manifold -Carter Competition Carb

'86 Camaro
2.8 MPFI
(for sale) -> needs new engine

Jul 21, 2001 | 10:46 PM

un4givin89

Banned

Joined: Jun 2001

Posts: 2,228

Likes: 1

From: Lan Terminal

always pay more attention you take something off. Make a note of its postion, take a picture or mark your bolts and there places, i find fingernail paint works great cuase it comes off easly.

[This message has been edited by un4givin89 (edited July 22, 2001).]

Jul 22, 2001 | 01:10 AM

breathment

Supreme Member

Joined: Jun 2001

Posts: 3,175

Likes: 1

From: Bedford, Tx

Get a manual, Haynes or Chiltons

------------------
88' GTA 350 MODS---> air foil, K&N, Shift Kit, 180* therm, TB bypass

Jul 22, 2001 | 07:28 AM

GTA88

Senior Member

Joined: Jul 1999

Posts: 760

Likes: 3

Just a hint. I remembered where all the bolts went, but it still wouldn't go back together until I loosened up some of the bolts, and wiggled the ps pump around to get it to line up ! On a Caprice.

------------------
88 GTA Charcoal Grey Bone Stock except for loose muffler which makes it a bit louder

than normal.