How do I get it back in?
Thread Starter
Member
Joined: May 2001
Posts: 133
Likes: 0
How do I get it back in?
Im almost done wiring my engine bay but Ive hit a problem with the harness for the heater/AC controls. I got the old wires out okay but Im having no luck getting the new ones through that little hole in the firewall. is there a trick to this anyonw would like to share with me? Thanks in advance.
Moderator
Joined: Jan 2000
Posts: 19,653
Likes: 309
TA,
It's a little late now, but for anyone else doing this, it's a good idea to use the old wiring to pull the new wiring through. At the least, tie a strong cord to the ends of the wires being removed. You can use the cord to pull the new wiring through at any time later.
For your situation, I would suggest using a stiff piece of wire (solid wire, like a coat hanger) to poke through the body grommet and use it to pull a cord or wires through.
Good luck.
------------------
Later,
Vader
------------------
"Let the bodies hit the floor!"
Adobe Acrobat Reader
It's a little late now, but for anyone else doing this, it's a good idea to use the old wiring to pull the new wiring through. At the least, tie a strong cord to the ends of the wires being removed. You can use the cord to pull the new wiring through at any time later.
For your situation, I would suggest using a stiff piece of wire (solid wire, like a coat hanger) to poke through the body grommet and use it to pull a cord or wires through.
Good luck.
------------------
Later,
Vader
------------------
"Let the bodies hit the floor!"
Adobe Acrobat Reader
Thread
Thread Starter
Forum
Replies
Last Post
Fronzizzle
Suspension and Chassis
6
Mar 18, 2019 08:29 PM
