where do i hook up a manual oil pressure gauge to
Thread Starter
Supreme Member
iTrader: (9)
Joined: Sep 1999
Posts: 3,871
Likes: 24
From: Mass
Engine: 350 TPI
Transmission: A4
Axle/Gears: 3.23
where do i hook up a manual oil pressure gauge to
I have an auto meter manual gauge and need to have it hooked up temporialy to see where the pressure is at onmy new crate motor. i dont trust the factory one.
Moderator
Joined: Jan 2000
Posts: 19,651
Likes: 309
There is a 1/8" NPT port on the rear ledge of the case, near the distributor. That connects directly to the oil galleries.
------------------
Later,
Vader
------------------
If you want to beat the World, it might reach up and pull you down...
Adobe Acrobat Reader
------------------
Later,
Vader
------------------
If you want to beat the World, it might reach up and pull you down...
Adobe Acrobat Reader
Moderator
Joined: Jan 2000
Posts: 19,651
Likes: 309
Correct. For a temporary connection, a little PTFE tape will work fine, but if it were a permanent installation, some pipe sealant would be best.
------------------
Later,
Vader
------------------
If you want to beat the World, it might reach up and pull you down...
Adobe Acrobat Reader
------------------
Later,
Vader
------------------
If you want to beat the World, it might reach up and pull you down...
Adobe Acrobat Reader
Thread
Thread Starter
Forum
Replies
Last Post
ambainb
Camaros for Sale
11
Apr 25, 2016 09:21 PM
92camaroJoe
Tech / General Engine
6
Aug 13, 2015 06:07 AM
