White smoke out the tail pipe.... new engine.... too rich??
Thread Starter
Supreme Member
Joined: Dec 2000
Posts: 1,536
Likes: 0
From: Springfield, MO, USA
Car: 1986 Trans Am, 1991 Firebird
Engine: 355 TPI, 3.1L V6
Transmission: 700R4 in both
White smoke out the tail pipe.... new engine.... too rich??
My new engine was just recently installed and I noticed today that it's blowing bluish white smoke out the tail pipes. The exhaust shop said that this is just moisture in the pipe. The car "smells" a little rich... could this bluish white smoke be caused by the car running rich?? I have pulled a plug yet to see what it looks like but I'll probably do that tomorrow. I also plan to put the car in "field service mode" and see if I can tell from that if it's running to rich or lean. As for the smoke... what could it be??
------------------
1986 Trans AM
355 TPI
4 Wheel Disc Brakes
9 bolt Borg Warner Rear (2.77's....oh joy) :P
6" rods, approx. 9.7:1 Compression, Stock TPI (soon to be ported), 24#/hr LTI injectors (cleaned and flowmatched by Cruizin Performance), Hedman Shorty Headers, 3" exhaust with 80 series flowmaster, SBC 993 heads completely redone and modified for 1.6 RR, 1.52 RR (for now), Comp Cams XE262-14 TPI Cam, Holley AFPR, TPIS airfoil, MSD wires, MSD 6-AL Ignition, Hypertech 53,000 volt coil.
Track times to come.
------------------
1986 Trans AM
355 TPI
4 Wheel Disc Brakes
9 bolt Borg Warner Rear (2.77's....oh joy) :P
6" rods, approx. 9.7:1 Compression, Stock TPI (soon to be ported), 24#/hr LTI injectors (cleaned and flowmatched by Cruizin Performance), Hedman Shorty Headers, 3" exhaust with 80 series flowmaster, SBC 993 heads completely redone and modified for 1.6 RR, 1.52 RR (for now), Comp Cams XE262-14 TPI Cam, Holley AFPR, TPIS airfoil, MSD wires, MSD 6-AL Ignition, Hypertech 53,000 volt coil.
Track times to come.
Member
Joined: Jul 1999
Posts: 239
Likes: 0
From: Okarche, OK, USA
bluish smoke is oil. if the motor is new, it could be the rings havn't seated. see the shop that built the engine and see if they have any suggestions.
------------------
Kyle Osterholt
Okarche, Oklahoma
ASE Master Certified
86 T/A 383 TPI
89 TTA #1002 T-top/Leather
89 TTA #1358 Hardtop/Leather
80 T/A Pace Car
73 Opel GT
73 bronco
2000 Ducati 996 Monoposto
83 MSE #52
------------------
Kyle Osterholt
Okarche, Oklahoma
ASE Master Certified
86 T/A 383 TPI
89 TTA #1002 T-top/Leather
89 TTA #1358 Hardtop/Leather
80 T/A Pace Car
73 Opel GT
73 bronco
2000 Ducati 996 Monoposto
83 MSE #52
Thread Starter
Supreme Member
Joined: Dec 2000
Posts: 1,536
Likes: 0
From: Springfield, MO, USA
Car: 1986 Trans Am, 1991 Firebird
Engine: 355 TPI, 3.1L V6
Transmission: 700R4 in both
<font face="Verdana, Arial" size="2">Originally posted by snakeskinner:
bluish smoke is oil. if the motor is new, it could be the rings havn't seated. see the shop that built the engine and see if they have any suggestions.
</font>
bluish smoke is oil. if the motor is new, it could be the rings havn't seated. see the shop that built the engine and see if they have any suggestions.
</font>
------------------
1986 Trans AM
355 TPI
4 Wheel Disc Brakes
9 bolt Borg Warner Rear (2.77's....oh joy) :P
6" rods, approx. 9.7:1 Compression, Stock TPI (soon to be ported), 24#/hr LTI injectors (cleaned and flowmatched by Cruizin Performance), Hedman Shorty Headers, 3" exhaust with 80 series flowmaster, SBC 993 heads completely redone and modified for 1.6 RR, 1.52 RR (for now), Comp Cams XE262-14 TPI Cam, Holley AFPR, TPIS airfoil, MSD wires, MSD 6-AL Ignition, Hypertech 53,000 volt coil.
Track times to come.
Senior Member
Joined: Jan 2001
Posts: 527
Likes: 0
From: outerspace(maybe..pluto)?
maybe a cigarette got sucked down a runner??? ............would explain the smoke 
------------------
89 firebird formula
360 10:1compression (350 .060 over)/fully balnced and blueprinted
comp cams xe262 cam
performer rpm intake/port matched to heads
#1405edlebrock 600
sportsman 2 heads 64cc 2.02/1.60 valves 200cc intake runner/cnc pocket ported
msd 6al/msd8.5 super condutor wires
h.e.i. proform 50,000 volt vac. advance ditributor
700r-4 with 3.08 first gear and 3.73 7 5/8 rear end.
b trans shift kit(will kill shifts...suck dong!!)
shorty heddman hedders with custom 3" pipe y-pipe back(no damn cat!) with 40 series flowmaster!
griffin daul1" core rad.cutom fabrication to fit(but no cutting )
future mods: 406 roller REALLY REALLY REALLY RADICAL!!!!!.with lots of NOS
------------------
89 firebird formula
360 10:1compression (350 .060 over)/fully balnced and blueprinted
comp cams xe262 cam
performer rpm intake/port matched to heads
#1405edlebrock 600
sportsman 2 heads 64cc 2.02/1.60 valves 200cc intake runner/cnc pocket ported
msd 6al/msd8.5 super condutor wires
h.e.i. proform 50,000 volt vac. advance ditributor
700r-4 with 3.08 first gear and 3.73 7 5/8 rear end.
b trans shift kit(will kill shifts...suck dong!!)
shorty heddman hedders with custom 3" pipe y-pipe back(no damn cat!) with 40 series flowmaster!
griffin daul1" core rad.cutom fabrication to fit(but no cutting )
future mods: 406 roller REALLY REALLY REALLY RADICAL!!!!!.with lots of NOS
Thread Starter
Supreme Member
Joined: Dec 2000
Posts: 1,536
Likes: 0
From: Springfield, MO, USA
Car: 1986 Trans Am, 1991 Firebird
Engine: 355 TPI, 3.1L V6
Transmission: 700R4 in both
<font face="Verdana, Arial" size="2">Originally posted by burnoutrpm:
maybe a cigarette got sucked down a runner??? ............would explain the smoke
</font>
maybe a cigarette got sucked down a runner??? ............would explain the smoke
</font>
Senior Member
Joined: Mar 2001
Posts: 953
Likes: 0
From: LONGVIEW TX . USA
<font face="Verdana, Arial" size="2">Originally posted by burnoutrpm:
maybe a cigarette got sucked down a runner??? ............would explain the smoke
</font>
maybe a cigarette got sucked down a runner??? ............would explain the smoke
</font>
Thread
Thread Starter
Forum
Replies
Last Post
Pac J
Tech / General Engine
3
May 17, 2020 10:44 AM
