Tech / General Engine Is your car making a strange sound or won't start? Thinking of adding power with a new combination? Need other technical information or engine specific advice? Don't see another board for your problem? Post it here!

Sponsored by:

Hydraulic Throwout Bearing Adapter

Reply Subscribe

Search this Thread

Old

Dec 27, 2005 | 04:12 PM

#1

Thread Starter

Junior Member

Joined: Oct 2004

Posts: 47

Likes: 0

From: Maine

Car: 86 IROC-Z

Engine: 97 LT1

Transmission: T56

Hydraulic Throwout Bearing Adapter

I just purchased a Mcleod 1400-22 throwout bearing to place with my 97 Camaro Clutch master cylinder. The two ends aredifferent. Is there an adapter? Do I need a new hose from the master cylinder? Do I need a whole new hydraulic set up? This must have been done before.

Reply Subscribe

Related Topics

Thread

Thread Starter

Forum

Replies

Last Post

Using GM drac instead of SGI-5 box?

InfernalVortex

Electronics

10

Apr 20, 2021 11:31 AM

backlash and carrier shims

gord327

Transmissions and Drivetrain

19

Oct 3, 2015 01:25 PM

tpi swap, fuel system questions

dusterbd

TPI

0

Sep 29, 2015 08:40 AM

Shudder on takeoff when warm

mfp189

Transmissions and Drivetrain

1

Sep 27, 2015 09:25 AM

Wheel Spacers - Good or Bad

dbrochard

Wheels and Tires

2

Sep 25, 2015 05:40 PM

1997, 91, adapter, bearing, camaro, cylinder, fbody, gen, gm, hose, hydralic, hydraulic, master, setup, throw, throwout

First
Prev
1 / 1
Next
Last

All times are GMT -5. The time now is 03:16 PM.