Need to make a cam decision soon
Thread Starter
Junior Member
Joined: Jan 2006
Posts: 95
Likes: 0
From: northern maine usa/
Car: 1988 iroc/2000 saab 9-5
Engine: 355 tpi/Roller cam
Transmission: 700r4/2800 stall,megashifter
Axle/Gears: 3;42
Need to make a cam decision soon
crane #104224
crane #104204
ZZ4 or ZZ9.
WHICH WOULD BE BEST?
this is what i got,
88 iroc z tpi 5.7
30 over block
stock iron heads,ported,new valves,stock, 3 angle.
forged alum pistons ,4 valve reliefs new
stage 1 rods new
cast crank,stock new
comp.is totally stock,no upgrades,stock chips.
prob going with 24 lb injects, not ordered yet.
want a bigger than stock cam,that will work with this basic rebuild,without any prom work,or very little.
also should throw a chip in while i got my comp, out,
any advise would be great,gotta order a cam and maybe a chip this week,please throw some prt#s if possible,
thankx
crane #104204
ZZ4 or ZZ9.
WHICH WOULD BE BEST?
this is what i got,
88 iroc z tpi 5.7
30 over block
stock iron heads,ported,new valves,stock, 3 angle.
forged alum pistons ,4 valve reliefs new
stage 1 rods new
cast crank,stock new
comp.is totally stock,no upgrades,stock chips.
prob going with 24 lb injects, not ordered yet.
want a bigger than stock cam,that will work with this basic rebuild,without any prom work,or very little.
also should throw a chip in while i got my comp, out,
any advise would be great,gotta order a cam and maybe a chip this week,please throw some prt#s if possible,
thankx
Thread
Thread Starter
Forum
Replies
Last Post
1992 Trans Am
Suspension and Chassis
1
Aug 9, 2015 04:32 PM
