K-member swap, how to support engine?
K-member swap, how to support engine?
I'm going to be swapping the k-member out on my 82 this weekend. I don't have a Cherry picker or anything so I need to support the engine somehow while I do the swap. Do you guys think it would be safe to place a board across the bottom of the oil pan and support it that way via a jack or jackstand? any other suggestions?
Joined: Sep 2005
Posts: 27,861
Likes: 2,427
Car: Yes
Engine: Usually
Transmission: Sometimes
Axle/Gears: Behind me somewhere
I don't have a Cherry picker
Cheaper that way, than to buy an oil pan to replace the one you crush, AND rent a cherry picker.
Thread
Thread Starter
Forum
Replies
Last Post
NBrehm
Engine/Drivetrain/Suspension Parts for Sale
0
Aug 5, 2015 07:57 PM






