cam advice for goodwrench 350
Thread Starter
Junior Member
Joined: Sep 2004
Posts: 59
Likes: 0
From: north jersey
Car: 86 iroc. white.
Engine: goodwrench 350 (stock for now)
Transmission: monster trans 700r4
Axle/Gears: 2.73 ( want 3.73s , gimme a holla)
cam advice for goodwrench 350
checked out the search on this one, couldn't find a clear answer.
i wanna swap cams on my goodwrench 350 , want to know whats the most radical cam i can put in there using the stock heads. i dont have the cash to drop on new heads just yet but the cam swap will be cheap and bump up the horsepower enough to make me happy for now. i already have full exaust, intake, a good trans, and a 3.27 9 bolt so im pretty good as far as bolt ons go. thank you in advance.
i wanna swap cams on my goodwrench 350 , want to know whats the most radical cam i can put in there using the stock heads. i dont have the cash to drop on new heads just yet but the cam swap will be cheap and bump up the horsepower enough to make me happy for now. i already have full exaust, intake, a good trans, and a 3.27 9 bolt so im pretty good as far as bolt ons go. thank you in advance.
Joined: Mar 2000
Posts: 43,187
Likes: 43
From: Littleton, CO USA
Car: 82 Berlinetta/57 Bel Air
Engine: L92/LQ4 (both w/4" stroke)
Transmission: 4L80E/4L80E
Axle/Gears: 12B-3.73/9"-3.89
The heads can't handle a lot. But, something below .480" lift will probably be okay (as long as you get new springs, too). XE268, perhaps.
Thread
Thread Starter
Forum
Replies
Last Post
