Compatable Combo?
Thread Starter
Supreme Member
iTrader: (1)
Joined: Jun 2004
Posts: 1,663
Likes: 0
From: Menominee MI
Compatable Combo?
350 engine (.030 over bore)
Mild Ported Aluminum L98 Heads
276HR cam - .503/.510 lift 224/230 duration at .050
1.6 ratio RR's
Airgap Intake
650 CFM Carb (undecided yet)
do you guys think this will run and perform alright? i'm looking to make a nice driving, stout small block..
rearend has 3.73's in it, and i'll have a 3000 rpm stall converter
The bottom end is already built, the intake part is what I'm most concerned about matching up...also if anybody has any ideas on HP/TQ numbers, post it, I know its hard to tell with all the variables involved...
Mild Ported Aluminum L98 Heads
276HR cam - .503/.510 lift 224/230 duration at .050
1.6 ratio RR's
Airgap Intake
650 CFM Carb (undecided yet)
do you guys think this will run and perform alright? i'm looking to make a nice driving, stout small block..
rearend has 3.73's in it, and i'll have a 3000 rpm stall converter
The bottom end is already built, the intake part is what I'm most concerned about matching up...also if anybody has any ideas on HP/TQ numbers, post it, I know its hard to tell with all the variables involved...
Supreme Member
iTrader: (5)
Joined: Jan 2002
Posts: 13,622
Likes: 5
From: Orland Park, IL
Car: 1984 Z28
Engine: SLOW carbed ls
Transmission: TH400 with brake, 8" PTC converter
Axle/Gears: moser 9" 4.11
performer RPM air-gap for sure. and a 750 double pumper holley or proform carb.
Thread
Thread Starter
Forum
Replies
Last Post
roysatikas
Transmissions and Drivetrain
0
Sep 22, 2015 08:15 PM
