ok as some of you know i what to get rid of the pollution crap on my motor.i was wondering if i take the stainless steel tubing off my headers(stock) can i just block them off?will that hurt my exhaust back presser or will it be better?

 

I have a full edelbrock exhaust from front to back. I recently cut all of the air tubes off the headers and had the holes welded up and opened up the cat. conveter and I did have any problems. I am now selling the hole system to upgrade to longtube headers and have true dual exhaust.

 

so you didn't have any problems? your post says " did'' but the way you got it,it sounds like you didn't.thanx for the reply

 

I didnt have any problems. You should be fine

 

,i just ordered a performer(non EGR) intake today,can't wait to get all my stuff back together

 

on stock manfolds just unscrew the tube and put in a plug ie bolt and tighten it down .... looks better then a weld imo....tao

 

yepp,thats what i was gonna do.was out yesterday and a f#@!ing chip munk chewed some of my wires off 4 my power window switch .luckyly i got another from my buddy.guess i'll have to leave the cat out in the garage for a few nights