hp est
Thread Starter
Junior Member
Joined: Nov 2006
Posts: 7
Likes: 0
Car: '92 RS 25th Anni
Engine: 305TBI
Transmission: 700R4
hp est
I was wondering if anyone here who has a desktop dyno would be kind enough to run a hp est on this engine set up
350 4bolt main out of a 84 chevy p/u
stock heads ported and polished
edelbrock performer eps intake
Operating Range:1300-5600 RPMDuration Advertised:262° Intake / 270° ExhaustDuration @ .050'' Lift:218° Intake / 224° ExhaustValve Lift w/1.5 Rockers:.462'' Intake / .469'' ExhaustLobe Separation Angle:110°
Holley Commander 950 TBI System 700 CFM
the exhaust is gonna be a 1 5/8" 3" exhast system dumped after the muffler
would also appreciate any and all advice on better setups like cam/intake the heads are gonna be stock port and polished until i can afford some afr's
350 4bolt main out of a 84 chevy p/u
stock heads ported and polished
edelbrock performer eps intake
Operating Range:1300-5600 RPMDuration Advertised:262° Intake / 270° ExhaustDuration @ .050'' Lift:218° Intake / 224° ExhaustValve Lift w/1.5 Rockers:.462'' Intake / .469'' ExhaustLobe Separation Angle:110°
Holley Commander 950 TBI System 700 CFM
the exhaust is gonna be a 1 5/8" 3" exhast system dumped after the muffler
would also appreciate any and all advice on better setups like cam/intake the heads are gonna be stock port and polished until i can afford some afr's
Joined: Jan 2005
Posts: 10,450
Likes: 510
From: Hurst, Texas
Car: 1983 G20 Chevy
Engine: 305 TPI
Transmission: 4L60
Axle/Gears: 14 bolt with 3.07 gears
Properly tuned with the smog heads, even ported and polished I am going to say 275 FWHP @ 4,500 and 350 ft/lbs @ 3,000.
Thread
Thread Starter
Forum
Replies
Last Post