i need to know where to buy the high side line that goes from a type two pump to the box it only needs to be like a foot long

these are the fittings i need

Any parts store should have a stock hose.

it is not a stock pump and it is not in the stock location

the bigger one that goes in the box is an 18 mm i got that from searching
the smaller one is a 5/8 wrench size

Try the yellow pages under "Hydraulics" then to get a custom hose made.

i called all the places in town no one can make a hose with o ring fittings on the ends but i think i may have found the solution

for the box
http://www.performancebodies.com/sto...pf%5Fid=101230

for the pump because 16 mm and 5/8 are almost the same size
http://www.performancebodies.com/sto...pf%5Fid=101220

They're called "Saginaw" fittings... Earl's makes adapters to use AN fittings with them.

Russel's and earls both make adapters for that fitting to AN fittings.
then have a regular AN hose made to fit.
This is similar to what you need.

http://store.summitracing.com/partde...5&autoview=sku



You all beat me to it.

is the o ring needed on the pump side or can i use this
http://store.summitracing.com/partde...5&autoview=sku

That fitting is an inverted flare. It's a different beast entirely. You need the O ring.

the pump is a profile pump would anyone know what size fitting it is.