ok when sitting about 100KMph or 62Mph i get a bad vibration through the flore, it has only just started in the last fue weeks (i get the Express way every morning on the way to work and on the way home so i hit this speed fairly often).

I don't evan know if this post it is ment to go here i just need to get this sorted ASAP, any help would be greatly appresiated.

 

Check exhaust components for clearance to the floor pan and the frame. Also check the front and rear universal joints on the driveshaft, torque arm mount to transmission, rear crossmember and trans mount bolts.

 

I know that I have 1 shot engine mount (RHS under my steering colum, complete PITA to get to) and a bum gearbox mount coz if i plant my foot my gearbox hits the flore (I know there is no point in doing the gearbox mount till I have the time to fix the engine mount coz it will just brake again).

But they have been stuffed for ages so i doubt that they are causing this new problem.

I will look over the uni joints and torque arm mounts when i get a chance.
Thanks

 

Your lack of tranny mounts may have wore out your u-joints from all the moving around.

 

nub question but where r the u-joints?

 

driveshaft