a guy sent me an email about giving me everything for carb including intake fuel pump regulator coil distributor ect. ect. to do this swap for a trade for ALL of my tbi stuff..which is good cuz i'd just throw it away anyway...he didnt inform me until about last minute that the heads on his engine that these part s are coming off of were 55-86 b/c this was a crate engine. will the intake bolt up to my 89 lo3? or what do i have to do.cuz i cant CANT afford new heads right now...thanks for the input i hope you guys can feel my stress by now lol..

 

you have to oval the 4 center bolt holes on the intake

 

ok so tell him that the deal is still on i suppose. just take a dremel and oval them out huh? that sounds simple enough.

 

any chance someone can give me a step through list on what to do and maybe some photos or direct me to an old thread about this??