Valve Lash
Joined: Sep 2005
Posts: 27,871
Likes: 2,430
Car: Yes
Engine: Usually
Transmission: Sometimes
Axle/Gears: Behind me somewhere
Re: Valve Lash
Hot.
Although, since it's a hydraulic, the difference is insignificant.
Remove valve covers. Start engine. Back each one off, one at a time, until it ticks. Re-tighten slowly until it JUST BARELY quits ticking. Do all 16 as quick as you can. Turn off engine. Tighten each one ½ turn more. Put valve covers back on.
Although, since it's a hydraulic, the difference is insignificant.
Remove valve covers. Start engine. Back each one off, one at a time, until it ticks. Re-tighten slowly until it JUST BARELY quits ticking. Do all 16 as quick as you can. Turn off engine. Tighten each one ½ turn more. Put valve covers back on.
Thread
Thread Starter
Forum
Replies
Last Post
355tpipickup
Tech / General Engine
9
Sep 13, 2015 11:35 PM
dimented24x7
Tech / General Engine
4
Sep 6, 2015 03:51 PM
