Hard Start
Supreme Member
iTrader: (1)
Joined: Jul 2004
Posts: 10,763
Likes: 4
From: Calgary, AB, Canada
Car: 1982 Trans-Am
Engine: 355 w/ ported 416s
Transmission: T10, hurst shifter
Axle/Gears: 10 bolt, true-trac, 3.73
Re: Hard Start
You need to focus on your one thread in the carb board and figure out your choke settings. Chances are it's WAY off, and maybe your acc pump is leaking and/or the float bowl leaks.
A carb rebuild may be in order, then set it all up right and you should be fine.
A carb rebuild may be in order, then set it all up right and you should be fine.
Thread
Thread Starter
Forum
Replies
Last Post
92camaroJoe
Tech / General Engine
6
Aug 13, 2015 06:07 AM





