Which type of roller rockers would be most beneficial for my motor.. its a 350 bored out .30 over with stock heads and a cam with these specs..:

Cam/Lifter Kit Advertised Intake Duration: 282
Advertised Exhaust Duration: 282
Advertised Duration: 282 int./282 exh.
Intake Duration at 050 inch Lift: 224
Intake Valve Lift with Factory Rocker Arm Ratio: 0.465 in.
Exhaust Valve Lift with Factory Rocker Arm Ratio: 0.465 in.
Exhaust Duration at 050 inch Lift: 224
Lobe Separation (degrees): 114
Duration at 050 inch Lift: 224 int./224 exh.
Valve Lift with Factory Rocker Arm Ratio: 0.465 int./0.465 exh. lift

 

imo
if you are questioning the rockers then you are questioning your cam

 

i'm questioning which rockers would go best with the cam

 

Whatever rockers you can afford. You don't have a lot of lift to need anything special.

That looks like some sort of power adder cam with the long duration and short lift.

 

yea i bought the cam w/ an intake and carb kit from summit... i just got another set of stock heads b/c mine were shot and i can't afford a set of aluminum ones that i want.. but i have some left over for the roller rockers... would a set of 1.6 rockers work ok?

 

1.6 rockers would be pushing the limits of the stock springs. It's still under .500 lift but it's getting close.