Tech / General Engine Is your car making a strange sound or won't start? Thinking of adding power with a new combination? Need other technical information or engine specific advice? Don't see another board for your problem? Post it here!
Sponsored by:
Sponsored by: CARiD

pulled codes and ......

Old May 24, 2008 | 10:10 AM
  #1  
sinisterrs's Avatar
Thread Starter
Junior Member
 
Joined: Apr 2008
Posts: 46
Likes: 0
From: Needville
Car: 1991 Camaro RS
Engine: 305 5.0
Transmission: 700r4
Axle/Gears: 2.73's
pulled codes and ......

well my car was been getting a little hard to start when its cold and running rich so i pulled codes this morning and i found quite a bit out with whats going on ......54 Low voltage at fuel pump OR Low voltage at Fuel pump relay OR Output failure at quad driver module....23 Low temperature at manifold air temperature sensor OR Throttle position sensor error.....32Fault in barometric pressure sensor circuit OR Fault in exhaust gas recirculation valve diagnostic switch OR Fault in electronic vacuum regulator valve..... my question is where do i start?....i gonna put relay and check fuel pressure but then what?
Reply
Old May 24, 2008 | 11:11 PM
  #2  
sinisterrs's Avatar
Thread Starter
Junior Member
 
Joined: Apr 2008
Posts: 46
Likes: 0
From: Needville
Car: 1991 Camaro RS
Engine: 305 5.0
Transmission: 700r4
Axle/Gears: 2.73's
Re: pulled codes and ......

anyone?
Reply
Old May 24, 2008 | 11:22 PM
  #3  
1fastam's Avatar
Member
iTrader: (1)
 
Joined: Oct 2006
Posts: 442
Likes: 0
From: oxford n.c.
Car: 1991 transam
Engine: 305 30 over long tubes into 3" y
Transmission: 700r4
Axle/Gears: 4:10
Re: pulled codes and ......

unhook battery for five minutes rehook crank and drive then recheck codes and go from there. those codes were probably set at different times,later jimmy
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
chazman
Tech / General Engine
8
Aug 28, 2018 03:25 PM
C409
Engine/Drivetrain/Suspension Parts for Sale
1
Sep 1, 2015 03:42 PM
86IROC112
Tech / General Engine
2
Aug 31, 2015 07:00 AM
chazman
TPI
0
Aug 22, 2015 02:01 PM


Thread Tools
Search this Thread

All times are GMT -5. The time now is 10:10 AM.