I have some left over steel braided line from my corvette project and I want to use them to replace my old britle hoses and rusted lines on my 89. What adapters do I need to go from the fittings on the tpi fuel rail to my braided line? I also plan on cutting back the factory hard line that runs up under the master cylinder due to extreme rust, I'm going to cut it back a foot or two to get rid of the rusted section and than go from the hard line to the braided line there, any idea what adapters I need for that? I'm not sure what size the factory feed and return lines are or anything.. thanks in advance for any help you guys can give me!