Ignition timing with cc306
Thread Starter
Junior Member
Joined: Oct 2006
Posts: 56
Likes: 0
From: Mississippi
Car: 1985 IROC
Engine: lb9
Transmission: 700R4 B&M shiftkit
Axle/Gears: 3.42s
Ignition timing with cc306
What should i set the timing at with the cc306 cam. I'm running a carb and a vacuum advance hei distributor. The specs on the cam are 230/244 duration .510/.540 lift. The advertised duration is 290/306. Operating range is 2000-6000, but it's underrated and peaks at 6300.
If these may be of any help, here are the motor specs:
355
Forged flat top pistons 9.73:1 compression
ported vortec heads
holley 3310 750cfm vacuum secondary carb
summit hei vacuum advance distributor
stealth air strike intake
If these may be of any help, here are the motor specs:
355
Forged flat top pistons 9.73:1 compression
ported vortec heads
holley 3310 750cfm vacuum secondary carb
summit hei vacuum advance distributor
stealth air strike intake
On Probation
Joined: Oct 2008
Posts: 6,319
Likes: 19
From: Northern Utah
Car: seeking '90.5-'92 'bird hardtop
Engine: several
Transmission: none
Axle/Gears: none
Re: Ignition timing with cc306
Best timing is determined by the heads, not the cam. Those Vortecs do best with 30-34 degrees total centrifugal advance.
Thread
Thread Starter
Forum
Replies
Last Post
Ghettobird52
Tech / General Engine
16
Jul 5, 2024 11:18 PM
