building a motor for my dad. what do you think?
Thread Starter
Senior Member
iTrader: (2)
Joined: Feb 2007
Posts: 805
Likes: 0
From: anderson ,sc
Car: 89 formula/00 z28
Engine: carbed 350/ls1
Transmission: 700r4/ a4
Axle/Gears: 3.23 posi/ 3.73 posi
building a motor for my dad. what do you think?
350 stock bore. Lt1 piston, gm .028 head gasket, 61cc vortec heads head work been done. should have 10.3 to 1 cr, xr276hr cam, summit stage one intake, 650 dp,hei... will this make around 375 - 400 at fly wheel?
Joined: Mar 2000
Posts: 43,187
Likes: 42
From: Littleton, CO USA
Car: 82 Berlinetta/57 Bel Air
Engine: L92/LQ4 (both w/4" stroke)
Transmission: 4L80E/4L80E
Axle/Gears: 12B-3.73/9"-3.89
It should, assuming proper tune and good exhaust, but you'd be better off with a better intake manifold.
Thread Starter
Senior Member
iTrader: (2)
Joined: Feb 2007
Posts: 805
Likes: 0
From: anderson ,sc
Car: 89 formula/00 z28
Engine: carbed 350/ls1
Transmission: 700r4/ a4
Axle/Gears: 3.23 posi/ 3.73 posi
Re: building a motor for my dad. what do you think?
well the intake he has done bought. but cam he has not yet. it dont have any exhaust yet trying to get the motor togather. i think his going with a 700r4 with stock converter and 3.73. what would be best cam to go with the above? his wanting around 375 - 400 at the fly wheel horsepower.
Thread
Thread Starter
Forum
Replies
Last Post