Vacuum "Ball" Question
Thread Starter
Supreme Member
Joined: Sep 2002
Posts: 9,192
Likes: 19
From: Cary, North Carolina
Car: 1992 RS
Engine: Carbed 350
Transmission: 700R4
Axle/Gears: 3.42 posi
Vacuum "Ball" Question
I know the vacuum "ball" under the driver front is meant to 'hold a vacuum' for things. What is affected by removing this "ball"?
I'm 350 carbed, no ECM. Brake booster gets vacuum directly from carb, so no brake issues right? My TC lockup gets vacuum off this line - but no need to have the TC lockup if no running engine. Only thing left I can think of is the vacuum actuated heater controls. And I can't see a need to run them without motor running either.
I'm 350 carbed, no ECM. Brake booster gets vacuum directly from carb, so no brake issues right? My TC lockup gets vacuum off this line - but no need to have the TC lockup if no running engine. Only thing left I can think of is the vacuum actuated heater controls. And I can't see a need to run them without motor running either.
Thread
Thread Starter
Forum
Replies
Last Post
mdtoren
Tech / General Engine
0
Aug 16, 2015 05:45 PM
