will this cam work or not?
Thread Starter
Junior Member
Joined: Feb 2010
Posts: 81
Likes: 0
will this cam work or not?
i have a 1989 chevy 350 im putting together with vortec heads, and flat top pistons and ill have roughly 10:1 CR but will this cam fit in my engine? if not can i do anything to make it fit?
http://www.summitracing.com/parts/SUM-K1107/
http://www.summitracing.com/parts/SUM-K1107/
Moderator
Joined: Jan 2000
Posts: 20,981
Likes: 11
From: Mercedes Norte, Heredia, Costa Rica
Car: 1984 Z28 Hardtop
Engine: 383 Carb
Transmission: 4L60
Axle/Gears: 3.54 Dana 44
Re: will this cam work or not?
It'll fit, but if your block is machined for it you could use a factory roller setup instead.
Supreme Member
iTrader: (3)
Joined: Nov 2001
Posts: 2,428
Likes: 2
From: Fairview Heights Illinois
Car: 1986 Irocz
Engine: 305 TPI
Transmission: 700R4
Axle/Gears: 3.25:1
Re: will this cam work or not?
i have a 1989 chevy 350 im putting together with vortec heads, and flat top pistons and ill have roughly 10:1 CR but will this cam fit in my engine? if not can i do anything to make it fit?
http://www.summitracing.com/parts/SUM-K1107/
http://www.summitracing.com/parts/SUM-K1107/
You still have to address the lift limit of the heads and whatever springs you intend to use. You'll also have to check for piston to valve contact.
The only way to know these things for sure is to measure what you've got with the parts you intend to use. There is no other way.
Thread
Thread Starter
Forum
Replies
Last Post
