Trying to set timing....
#1
Supreme Member
Thread Starter
Join Date: Feb 2007
Location: Andover, NJ
Posts: 1,275
Likes: 0
Received 0 Likes
on
0 Posts
Car: '88 Trans Am GTA; '84 Trans Am
Engine: L98 350TPI; 5.3 LSx built
Transmission: N/A; T56
Axle/Gears: 3.70 9 bolt; 3.73 10 bolt
Trying to set timing....
I'm starting over with my timing as its possible its out of wack. The problem I'm having is when I disconnect the 4 pin connector the car stumbles then stalls. I've read that the car should at least run abliet like crap when you do this. I want to ensure my base timing is dead on at 6 degrees, before I start taking apart the carb. Is it possible that the timing is out to the point where it won't run without the 4 pin connector attached? I have the dizzy marked so I can mess with it. I am going to be moving the dizzy lil by lil once I've established whether the timing is too far retarded or advanced.
Thread
Thread Starter
Forum
Replies
Last Post
82tabird
Engine/Drivetrain/Suspension Wanted
3
12-21-2015 10:22 PM
lt1z350
Engine/Drivetrain/Suspension Parts for Sale
3
09-29-2015 01:50 PM
[Sold] Accel 30# injectors
hydrolic144
Engine/Drivetrain/Suspension Parts for Sale
0
08-29-2015 04:14 PM
IROCZDAVE (88-L98)
Exterior Parts for Sale
0
08-24-2015 06:52 AM
mustangdmurder
Engine/Drivetrain/Suspension Parts for Sale
2
08-21-2015 07:17 PM