L98 Horse power????
Thread Starter
Member
Joined: Mar 2010
Posts: 110
Likes: 0
From: HURLEY, VA
Car: IROC-Z
Engine: 350 VORTEC
Transmission: T-56
Axle/Gears: 4.10
L98 Horse power????
L98 motor
horsepower tork
245@4400 345@3200
if i put shorty header,an a cat back hooker system, with a aftermarket Y pipe, with a mild cam, flat top piston bored 40 over, with MSD ignition. with a lil bit of porting done to the heads. what kind of horsepower could i git out of that???
horsepower tork
245@4400 345@3200
if i put shorty header,an a cat back hooker system, with a aftermarket Y pipe, with a mild cam, flat top piston bored 40 over, with MSD ignition. with a lil bit of porting done to the heads. what kind of horsepower could i git out of that???
Member
Joined: Aug 2009
Posts: 332
Likes: 0
From: AZ
Car: 1978 Chevrolet impala
Engine: 350ci 300hp/356tq pace crate
Transmission: 700r4
Axle/Gears: 3.42 Yukon posi
Re: L98 Horse power????
Uhhh that is a very broad, speculative question. Cam specs? CR? Pipe sizing? Lots of additional info needed
Joined: Mar 2000
Posts: 43,187
Likes: 42
From: Littleton, CO USA
Car: 82 Berlinetta/57 Bel Air
Engine: L92/LQ4 (both w/4" stroke)
Transmission: 4L80E/4L80E
Axle/Gears: 12B-3.73/9"-3.89
Maybe 225 at the wheels.
Why are you boring it 0.040" over?
Why are you boring it 0.040" over?
Senior Member
iTrader: (8)
Joined: Aug 2007
Posts: 1,341
Likes: 0
From: Southern Wisconsin
Car: 1988 Camaro
Engine: 383 Stroker
Transmission: Probuilt 700 R4
Axle/Gears: 3.73
Re: L98 Horse power????
I had edelbrock shorties, edelbrock alum heads, zz9 cam shaft, mini ram intake, 30lb injectors, 52mm throttle body and electric water pump, and a perfect tune, and only put down 292 to the rear wheels. So your going to need quite a bit more to reach that 300rwhp mark
Thread
Thread Starter
Forum
Replies
Last Post
sailtexas186548
Problems / Help / Suggestions / Comments
2
Aug 24, 2015 10:11 PM
