im in need of some ******* engineering
Thread Starter
Junior Member
Joined: Jul 2006
Posts: 91
Likes: 0
From: Sandtown Delaware
Car: 1987 pontiac Trans Am
Engine: 1988 305 TPI
Transmission: 700R4
Axle/Gears: 2:73 ... I think
im in need of some ******* engineering
I have been thinking about this for a while and probably gonna try it myself but i just did a 5sp swap on my 87 firebird and wanted to know if any one has been able to modify the auto shift plate for the manual shifter and it look decent. I know if it is done it will save alot of money for a lot of people and if any one has done it or has any ideas please post here and if i figure out a way ill be sure to post back. thanks.
Member
Joined: Apr 2010
Posts: 251
Likes: 0
From: phx,az
Car: 84 firebird, 85 transam
Engine: 350 SBC Or 7.07 Tonys,305stock
Transmission: Big Ugly, 700r4
Axle/Gears: 4th gen rear disk 3.42 lsd,9 bolt
Re: im in need of some ******* engineering
I have been thinking about this for a while and probably gonna try it myself but i just did a 5sp swap on my 87 firebird and wanted to know if any one has been able to modify the auto shift plate for the manual shifter and it look decent. I know if it is done it will save alot of money for a lot of people and if any one has done it or has any ideas please post here and if i figure out a way ill be sure to post back. thanks.
Thread
Thread Starter
Forum
Replies
Last Post
84z96L31vortec
Tech / General Engine
7
Aug 20, 2017 12:16 AM