camshaft help
Thread Starter
Member
Joined: May 2009
Posts: 178
Likes: 0
camshaft help
1989 350 out be of a iroc z stock motor. i will be changing cam, heads, lifters, intake. so here is what i got so far. 305 heads with the big valves, edelbrock performer intake(good to 5800-6000 rpm) and the CL12-600-4 camshaft and lifter kit (cam is good to 5800 rpm). this will be going into a camaro with a th350 tranny with a 2500 stall and 373 rear end gears. is this a good setup for a power house i wunna shoot for 12's. I'll take any suggestions.
Supreme Member
iTrader: (2)
Joined: Jul 2009
Posts: 1,354
Likes: 4
From: morrow, ga
Car: 82 S10, 83 280ZX, 84 Z28
Engine: 355 smallblocks..na, 2.8 turbo
Transmission: 85:th350, 84:700R4
Axle/Gears: 85:ford9 4.85, 84:stock 3.24
Re: camshaft help
if the stall is matched well and the heads are properly set up and no tire spin, 12s should be in your future.
Thread Starter
Member
Joined: May 2009
Posts: 178
Likes: 0
Re: camshaft help
well see thats another thing i have a 2500 but ican get a 3000 for free but im afraid it will be too much i already installed a tranny cooler cause of transmission heat issues but is a 3000 stall streetable?
Thread
Thread Starter
Forum
Replies
Last Post
88SS6SPEED
Engine/Drivetrain/Suspension Parts for Sale
7
Nov 11, 2015 07:05 AM
GTAman
Engine/Drivetrain/Suspension Parts for Sale
4
Sep 26, 2015 02:01 PM